ALABINE SM series instrument nameplate ink ALABINE SM series of ink for industrial polycarbonate (PC) material metering plate, Ming printed board and deliberately developed, inexpensive evaporation drying ink. This ink is a high-performance low-cost high-quality ink. Printing Printing polycarbonate (PC), acrylic resin materials automobile text panels, industrial meter board, nameplates, etc., as well as ABS, hard and soft PVC, wood products, such as: promotion purposes. Features: 1, does not make the material cracks, then Excellent; 2, excellent workability, not ink diffusion, not shrinkage phenomenon; 3, good flexibility, good after drilling and other processing adaptability; 4, oil, alcohol resistance and excellent chemical resistance. Usage: 1, please use the dedicated PC ALATIVE PB series dilution solvent (standard, slow drying, especially slow dry). When printing fine line drawing, use special ALATIVE PB6 slow dry solvent. Using other diluents, polycarbonate (PC) prone to cracking. 2, with a clean cloth without glue edge wire ALATIVE ST3 processing solution to wipe the surface of the plastic film, can effectively remove surface grease dirty plastic film itself has no effect. Drying: After the solvent was diluted with 20% of the PC print, finger contact time at room temperature as follows: PC standard solvent: about 15 minutes; PC slow drying solvent: about 20 minutes; PC Special slow drying solvent: about 25 minutes; Laid-lobed PC slow drying solvent: about 35 minutes Note: dial in automotive, industrial meter printed board, in order to prevent bad odor caused by residual solvent remaining recommended above 70 ℃ heating and drying. Version of cleaning: Wipe clean with a cleaning solvent screen please ALATIVE SC6. Color Packaging: more than 42 kinds of colors to choose from, each 1KG canned.